g228647
Figure 299
Machines with 2-wheel drive
1.
Motor housing
2.
Hub and spindle assembly 3.
Flange-head screw (7
each per side)
Removing the Rear Axle Motor Housings
1. Park the machine on a level surface, lower the cutting units, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Block the front wheels with chocks to prevent the machine from moving.
3. Remove the rear wheel assembly; refer to
Removing the Wheel (page 8–6)
.
4. Remove the cotter pin and slotted hex nut that secure the tie rod end (item
22 in
) to the drag link. Use a ball joint removal tool (pickle fork)
and separate the tie rod end from the drag link.
5. If the right side motor housing is being removed, remove the cotter pin and
slotted hex nut that secure the steering cylinder ball joint (item 25 in
) to the drag link. Use a ball joint removal tool (pickle fork) and separate
the steering cylinder from the drag link.
6. For the machines equipped with CrossTrax AWD, remove the 4 bolts (item
14 in
) and 4 lock washers that secure the wheel motor to the
motor housing. Slide the wheel motor assembly (with the wheel hub and
hydraulic hoses attached) from the motor housing. Position the wheel motor
away from the housing.
7. Support the motor housing to prevent it from falling.
Note:
Do not allow the wheel motor assembly to hang from the hydraulic
hoses.
8. Remove the flange-head screw (item 2 in
), spindle cap, and
retaining ring that secure the motor housing shaft into the axle tube. Slide the
motor housing out of the axle tube.
9. Locate and retrieve the thrust washer (item 7 in
) from the motor
housing shaft.
10. If necessary, remove the drag link from the motor housing.
11. If necessary, on 2-wheel drive machines, remove the hub and spindle
assembly (item 2 in
) from housing.
12. Clean the motor housing shaft. Inspect the shaft for wear and replace the
motor housing if the shaft is worn or damaged.
Reelmaster
®
5410/5510/5610 Series
Page 8–17
Chassis: Service and Repairs
15216SL Rev C
Summary of Contents for Reelmaster 5510 Series
