Toro Reelmaster 5510 Series, Service Manual

Page: 573 / 662

Front Roller
Removing the Front Roller
g214676
Figure 349
1. Cap screw 5. Carriage screw
2. Flat washer 6. Cap screw
3. Flange nut 7. Flange nut
4. HOC (roller) bracket 8. Front roller assembly
1. Park the machine on a clean and level surface, lower the cutting units, shut
off the engine, set the parking brake, and remove the key from the key switch.
2. Remove the cutting unit from the machine and place on a level working
surface. Use cutting unit kickstand (refer to (page ) ) to raise the front roller
from the work surface.
3. Loosen the flange nut and cap screw that secure the front roller shaft to
each front height-of-cut (roller) bracket.
4. On one of the height-of-cut (roller) brackets, do the following:
A. Remove the flange nut and carriage screw that secure the bracket to
the cutting unit side plate.
B. Remove the height-of-cut (roller) bracket from the cutting unit.
5. Slide the front roller assembly from the remaining height-of-cut (roller)
bracket on the cutting unit.
6. If necessary, remove the second height-of-cut (roller) bracket from the cutting
unit.
Installing the Front Roller
1. Place the cutting unit on a level working surface and use cutting unit
kickstand to support the cutting unit; refer to (page ) .
2. Inspect the condition of the cap screws (item 1) in both height-of-cut (roller)
brackets. Replace the bolt(s) if necessary:
A. Place the 2 flat washers on bolt and thread the flange nut onto the bolt to
a position 19 mm (0.750 inch) from screw head.
Reelmaster ® 5410/5510/5610 Series Page 9–43 Cutting Unit: Service and Repairs
15216SL Rev C