Disassembling the Control Arm (continued)
g185936
Figure 306
1.
Foam seal
2.
Platform wire harness
Assembling the Control Arm
1. Install all the electrical components that were removed from the control arm
(
).
2. Position the covers to the control arm. As the left control arm cover (item 32
in
) is placed, connect the wire harness connector to the headlight
switch. Also, ensure that the platform wire harness is routed correctly
through the cover openings and the harness foam seal is captured between
the control arm covers (
).
3. Secure each cover to the control arm with the 5 washer-head screws (item
15 in
). Install the screw (item 11 in
) and locknut to
secure the covers at the front of the control arm.
4. Install the access cover to outside of the control arm.
5. Connect the negative battery cable to the battery; refer to
.
Reelmaster
®
5410/5510/5610 Series
Page 8–25
Chassis: Service and Repairs
15216SL Rev C
Summary of Contents for Reelmaster 5510 Series
