Toro Reelmaster 5510 Series, Service Manual

Page: 578 / 662

Assembling the Roller
g195710
Figure 352
1. Roller tube 3. Inner seal tool
2. Inner seal
1. Install the inner seals into the roller tube and ensure that the seal lip (and
garter spring) faces end of the tube. Use the inner seal tool and soft-faced
hammer to fully seat seals against the roller shoulder; refer to
(page ) . Apply
a small quantity of grease around the lip of both inner seals after installation.
IMPORTANT
During assembly process, frequently check that the bearings
rotate freely and do not bind. If there is any binding, remove the
components and install them again.
2. Install a new bearing and the outer seals into one end of the roller tube as
follows:
g195711
Figure 353
1. Roller tube 3. Bearing
2. Inner seal 4. Bearing/outer seal tool
A. Position a new bearing into one end of the roller tube. Use the
bearing/outer seal tool with a soft-faced hammer to fully seat bearing
against the roller shoulder; refer to
(page ) . After the bearing installation,
ensure that the bearing rotates freely without binding.
B. Apply a small quantity of grease around the lip of both outer seals.
Cutting Unit: Service and Repairs Page 9–48 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C