Toro Reelmaster 5510 Series, Service Manual

Page: 117 / 662

Installing the Engine (continued)
10. Secure engine coolant reservoir and bracket to the fan shroud and radiator
frame ( Figure 55 ):
A. Position coolant reservoir and bracket to the fan shroud. Secure bracket
to fan shroud and radiator frame with 2 button-head screws and flange
nuts.
B. Connect overflow hose to radiator fill opening and secure with hose
clamp.
11. Install air cleaner assembly; refer to Air Cleaner Assembly (page 3–8) .
IMPORTANT
When installing the exhaust system, ensure to use the fastener
tightening order identified in
Exhaust System (page 3–11) .
12. Install exhaust system to machine; refer to Exhaust System (page 3–11) .
Exhaust tube should have 9.5 mm (3/8 inch) clearance with guard in all
directions after assembly.
13. Add engine coolant to radiator.
14. Check engine hydraulic-fluid level and adjust if necessary.
15. Close hood and connect positive (+) and then negative (-) battery cables to
the battery.
16. Prime the fuel system; refer to Priming the Fuel System (page 5–12) .
17. Start engine. Check for fluid leaks and proper engine operation.
18. After running engine for a short time, stop engine and ensure radiator and
hydraulic reservoir are full. Add correct fluids if necessary.
19. Lower and secure hood.
20. Install and secure screen to rear of machine.
Reelmaster ® 5410/5510/5610 Series Page 5–25 Kubota Gasoline Engine: Service and Repairs
15216SL Rev C