Toro Reelmaster 5510 Series, Service Manual

Page: 352 / 662

g228843
Figure 192
Reelmaster 5610
1. Oil cooler 6. Hose clamp 11. Bolt (2 each)
2. O-ring 7. Hydraulic fitting (2 each) 12. Screw (8 each)
3. Hydraulic fitting (2 each) 8. Flat washer 13. Oil cooler bracket
4. O-ring 9. Flange nut (4 each) 14. Mount plate (2 each)
5. Hydraulic fitting (2 each) 10. Clamp (2 each)
Note: The oil cooler used on Reelmaster 5410 and 5510 machines with a Kubota
diesel engine is Figure 191 . The oil cooler used on Reelmaster 5610 machines
with a Kubota diesel engine is shown in Figure 192 . Service procedures is similar
for all Reelmaster machines with a Kubota diesel engine.
Removing the Oil Cooler
1. Park machine on a level surface, lower cutting units, shut off the engine, set
the parking brake, and remove the key from the key switch.
2. Unlatch and open the rear screen.
3. Label all hydraulic connections for assembly purposes. Clean hydraulic
connections before you loosen the hydraulic hoses.
4. Loosen hose clamps that secure hydraulic hoses to oil cooler fittings.
Carefully remove hose ends from barbed fittings on oil cooler. Allow hoses to
drain into a suitable container.
5. Rotate clamps that secure oil cooler to radiator frame.
6. Carefully remove oil cooler from machine.
7. If necessary, remove clamps and brackets from oil cooler ( Figure 191 or
Figure 192 ).
8. If hydraulic fittings are to be removed from oil cooler on Reelmaster 5610
machines, mark fitting orientation to allow correct assembly. Remove fittings
from cooler and discard O-rings.
Hydraulic System: Service and Repairs Page 6–234 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C