Headlight Switch
g190997
Figure 245
1.
Control arm
2.
Headlight switch
The headlight switch is located on the operator side of the control arm (
). This rocker switch allows the headlights to be turned on and off.
Testing the Headlight Switch
1. Park the machine on a level surface, lower the cutting units, set the parking
brake, and shut off the engine.
2. Remove the left control arm cover to get access to the headlight switch; refer
to
Disassembling the Control Arm (page 8–23)
.
3. Ensure that the key switch is in the O
FF
position. Disconnect the wire harness
electrical connector from the headlight switch.
g223017
Figure 246
4. The headlight switch terminals are identified in
and the circuitry of
the switch is shown in the
Circuit Logic Table (page 7–72)
. With the use of a
multimeter (ohms setting), test the switch functions to determine if continuity
exists between the various terminals for each switch position. Check the
continuity between the switch terminals.
Circuit Logic Table
Switch Position
Normal Circuits
Other Circuits
O
N
2+3
5+6
O
FF
2+1
5+4
Note:
The headlight switch terminals 1, 4, 5, and 6 are not used on the
Reelmaster machines.
5. Replace the headlight switch if testing determines that the switch is damaged.
Electrical System: Testing the Electrical Components
Page 7–72
Reelmaster
®
5410/5510/5610 Series
15216SL Rev C
Summary of Contents for Reelmaster 5510 Series
