Toro Reelmaster 5510 Series, Service Manual

Page: 403 / 662

Adjusting the Traction Neutral Switch
1. Before adjusting the traction neutral switch, check and adjust the traction
system neutral position; refer to the Traction Unit Operator’s Manual .
IMPORTANT
To prevent the traction neutral switch damage, ensure that no
components contact switch through entire traction pump control
arm movement.
2. Park the machine on a level surface, set the parking brake, lower the cutting
units, shut off the engine, and remove the key from the key switch.
g213686
Figure 220
1. Traction pump 2. Pump lever 3. Traction neutral switch
3. When the traction pedal is in the N
EUTRAL
position, the gap between the
head of the neutral switch and the pump lever should be 2.4 to 2.5 mm
(0.094 to 0.100 inch) ( Figure 220 ).
4. If gap is incorrect, loosen the jam nuts that secure the neutral switch to the
pump plate. Position the switch with jam nuts to allow correct gap between
the switch and the pump lever. Torque the jam nuts to
18.4 to 22.4 N∙m
(162 to 198 in-lb) . After the jam nuts are tightened, ensure that clearance
between the head of the neutral switch and the pump plate has not changed.
5. After adjustment to the traction neutral switch, use the InfoCenter display
to verify that the traction neutral switch and circuit wiring are functioning
correctly; refer to
Using the InfoCenter Display for Troubleshooting (page
7–28) .
Reelmaster ® 5410/5510/5610 Series Page 7–47 Electrical System: Adjustments
15216SL Rev C