READ AND FOLLOW ALL SAFETY INSTRUCTIONS
DANGER
– RISK OF SHOCK – DISCONNECT POWER BEFORE INSTALLATION
CAUTION
– RISK OF FIRE. DO NOT INSTALL THIS LAMP IN A PRE-HEAT LUMINAIRE.
CAUTION
– RISK OF FIRE. USE ONLY IN LUMINAIRES THAT HAVE CONSTRUCTION
FEATURES
CAUTION
– RISK OF FIRE OR SHOCK. DO NOT OPEN OR MODIFY.
CAUTION
- RISK OF FIRE. IF THE LAMP OR LUMINAIRE EXHIBITS UNDESIRABLE OPERATION (BUZZING,
FLICKERING, ETC.), IMMEDIATELY TURN OFF POWER, REMOVE LAMP FROM LUMINAIRE AND CONTACT
MANUFACTURER.
NOT INTENDED FOR USE WITH EMERGENCY EXIT FIXTURES/LIGHTS.
THIS LAMP ONLY OPERATES ON ELECTRONIC BALLASTS. IF LAMP DOES NOT LIGHT WHEN THE LUMINAIRE
IS ENERGIZED, REMOVE LAMP FROM LUMINAIRE AND CONTACT LAMP MANUFACTURER OR QUALIFIED
ELECTRICIAN.
THIS RETROFIT KIT CAN REPLACE 36W 40W CFL LAMPS WITH 2G11 BASES.
THIS LAMP IS NOT COMPATIBLE WITH ALL BALLASTS. BEFORE INSTALLATION, CHECK COMPATABILITY OF LED
LAMPS AND LUMINAIRE BALLAST.
SUITABLE FOR DAMP LOCATIONS. DO NOT USE WITH DIMMERS.
THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS.
SEE MAXLITE.COM FOR BALLAST COMPATIBILITY.
© Copyright 2019. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
Page: 1
REV: 6/12/19
General Safety Information
Installation Instructions
1.
Turn off the power to the luminaire.
(Fig. 1)
2.
Remove diffuser (if provided).
3.
Remove the existing CFL lamps from the luminaire.
Verify the ballast is listed on the datasheet of MaxLite
PLL Directfit Series 14W. Confirm the lampholder has
a 2G11 socket.
4.
Install MaxLite LED PLL lamp into the open socket.
Ensure that the pins are firmly seated in the lampholders.
5.
Replace diffuser (if removed in step 2).
6.
Switch on power to the luminaire. (
Fig. 2
)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and (2)this device must accept any interference
received, including interference that may cause undesired operation
Operating Instructions
LED PLL DirectFit Series
MaxLite LED PLL DirectFit Series
®
Picture is for illustration
purposes only. Your model
may vary.
