Toro Reelmaster 5510 Series, Service Manual

Page: 56 / 662

Note: The engine removal and installation procedure is similar for all models
with a Kubota diesel engine.
Removing the Engine
1. Park machine on a level surface, lower cutting units, stop engine and remove
key from the key switch. Chock wheels to keep the machine from moving.
Open hood.
2. If engine is to be disassembled, drain oil from engine.
3. Disconnect negative (-) and then positive (+) battery cables from the battery.
CAUTION
Do not open radiator cap or drain coolant if the radiator or engine is
hot. Pressurized, hot coolant can escape and cause burns.
Ethylene-glycol antifreeze is poisonous. Dispose of coolant properly,
or store it in a properly labeled container away from children and pets
4. Drain coolant from radiator; refer to Radiator Assembly (page 3–17) .
5. Remove air cleaner assembly from machine; refer to Air Cleaner Assembly
(page 3–8) .
6. Remove exhaust system from machine; refer to Exhaust System (page 3–11) .
g229067
Figure 22
1. Throttle cable swivel 3. Cable stop 5. Cable clamp (2 each)
2. Locknut 4. Throttle cable clamp 6. Throttle cable
7. Remove throttle cable from injector pump ( Figure 22 ):
A. Remove Bolt that secures throttle cable end to swivel in speed control
lever.
B. Loosen throttle cable clamp (item 4 in Figure 22 ) and remove cable from
clamp. Slide throttle cable end from swivel.
C. Remove cable clamps that secure throttle cable to engine and driveshaft
brackets. Position throttle cable away from the engine.
8. Disconnect hoses from engine:
Kubota Diesel Engine: Service and Repairs Page 3–22 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C