Toro Reelmaster 5510 Series, Service Manual

Page: 574 / 662

Installing the Front Roller (continued)
B. Apply anti-seize lubricant to the threads of the bolt that will extend into
the height-of-cut (roller) bracket.
C. Thread the bolt into the bracket.
Note: When assembling the height-of-cut (roller) brackets to the side plate,
ensure that the bolt head and 1 washer are above the adjustment flange on
the side plate and second washer and flange nut are below the flange.
3. If both front height-of-cut (roller) brackets were removed from the cutting unit
side plate, position one of the brackets to the side plate. Secure the bracket
to the side plate with the carriage screw and flange nut.
4. Slide the front roller shaft into the bracket attached to the cutting unit. Slide
the second height-of-cut (roller) bracket onto the other end of the roller shaft.
Secure the second bracket to the cutting unit side plate with the carriage
screw and flange nut.
5. Apply Loctite #243 (or equivalent) to exposed threads of cap screw (item 1)
between flange of side plate and position of flange lock nut (item 3) on cap
screw. Tighten flange lock nut on cap screw and then loosen nut 1/4 to 1/2
turn. Cap screw should rotate freely with little (if any) endplay after lock
nut installation.
6. Apply Loctite #243 (or equivalent) to the threads of the 2 cap screws (item
6). Center the front roller to the cutting reel and secure in place with the 2
cap screws. Tighten the cap screws to
20 to 26 N∙m (15 to 19 ft-lb) . Secure
the cap screws with the flange nuts.
7. Lubricate the front roller.
8. Adjust the cutting unit; refer to the Cutting Unit Operator’s Manual .
Cutting Unit: Service and Repairs Page 9–44 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C