Service and Repairs
Hydraulic Reel Motor
IMPORTANT
When performing the maintenance procedures on the cutting units,
carefully position the cutting unit reel motors to prevent damage to
the motors or hydraulic hoses.
Removing the Hydraulic Reel Motor
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, shut off the engine, set the parking brake, and
remove the key from the key switch.
g214396
Figure 327
Cutting unit with cast iron side plate
1.
Hydraulic reel motor
3.
Relief vent
2.
Bolt (2 each)
4.
Grease fitting
2. Loosen the 2 bolts (item 2 in
) that secure the hydraulic reel motor
to the cutting unit side plate. Rotate the motor clockwise and remove the
motor from the cutting unit.
3. Place a protective plastic cap (refer to
(page )
) into the hole in the cutting unit
side plate to prevent unwanted material entering into the reel bearing area.
Installing the Hydraulic Reel Motor
Check the reel insert splines for wear. Replace the inserts if necessary; refer to
Reel Assembly Service (cutting units with painted side plates) (page 9–33)
or
(page )
.
Reelmaster
®
5410/5510/5610 Series
Page 9–17
Cutting Unit: Service and Repairs
15216SL Rev C
Summary of Contents for Reelmaster 5510 Series
