Toro Reelmaster 5510 Series, Service Manual

Page: 636 / 662

Assembling the Groomer Reel (continued)
2. Alternately install 31.7 mm (1−1/4 inch) spacers and blades, ensure that all
the blades are separated by a spacer.
3. When all the blades have been installed, place the remaining 6.3 mm (1/4
inch) spacer on the shaft. Install the second locknut onto the shaft. Center
the blades on shaft by adjusting locknuts.
4. Use the through holes in shaft to prevent the shaft from rotating, tighten
the second locknut to 42 to 48 N∙m (31 to 35 ft-lb) . After tightening the
locknut, spacers should not be free to rotate and the groomer blades should
be centered on the shaft.
5. If the groomer reel is equipped with the broomer kit:
A. Loosen the groomer blade retaining nuts on each end of the groomer
shaft.
g220499
Figure 400
1. Groomer reel 3. Blade
2. Broomer strap (4 each)
4. Brush
B. Slide a brush into each groove around the full length of the groomer reel.
Ensure that the brushes are seated in groomer blade slots ( Figure 400 ).
IMPORTANT
The straps must be wrapped around the groomer blade and brush
assembly in the correct direction.
C. Loosely wrap the straps around the groomer reel shaft and brushes as
shown in Figure 400 . The straps should be positioned in the pre-cut
notches of each brush between the blades 2-3, 14-15, 26-27, and 38-39.
Position the broomer brushes properly in the blade slots, and tighten the
groomer blade—retaining nuts to
42 to 48 N∙m (31 to 35 ft-lb) .
D. While holding strap buckle in place, pull the straps tight into the pre-cut
notches of each brush.
E. Cut off the strap extension approximately 6 mm (0.25 inch) beyond the
retainer and fold the excess strap over the buckle ( Figure 400 ).
6. Install the O-ring on the non-drive end of the groomer shaft.
7. Install the groomer reel back onto the cutting unit; refer to Groomer Reel
(page 11–13) .
Universal Groomer (Optional): Service and Repairs Page 11–16 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C