Rear Roller Brush – Optional (cutting units with aluminum side
plates)
g252763
Figure 364
1.
Brush bearing housing (non-driven) 8.
Flat washer (4 each)
15.
Lock nut
2.
Brush bearing housing (drive)
9.
Cap screw (4 each)
16.
J-bolt (2 each)
3.
O-ring
10.
Spacer
17.
Grease fitting (2 each)
4.
Roller brush shaft
11.
Flat washer (for pulley alignment)
18.
Grease seal (3 each)
5.
Flange nut (4 each)
12.
Driven pulley
19.
Ball bearing (2 each)
6.
Mounting bracket (2 each)
13.
Flange nut
7.
Excluder seal (2 each)
14.
Roller brush
Note:
Drive components for the rear roller brush are located on the opposite side
of the cutting unit from the cutting reel motor.
shows components
used when the brush drive is on the left side of the cutting unit.
Note:
The Installation Instructions for the rear roller brush kit has detailed
information regarding assembly and adjustment. Use those Instructions along
with this Service Manual when servicing the rear roller brush.
Disassembling the Rear Roller Brush
1. Position machine on a clean and level surface, lower cutting units, stop
engine, engage parking brake and remove key from the ignition switch.
2. To remove roller brush from brush shaft:
A. Remove the non-drive brush bearing housing (item 1) from cutting unit.
B. Slide excluder seal from roller brush shaft.
Reelmaster
®
5410/5510/5610 Series
Page 9–57
Cutting Unit: Service and Repairs
15216SL Rev C
Summary of Contents for Reelmaster 5510 Series
