Toro Reelmaster 5510 Series, Service Manual

Page: 494 / 662

Removing the Wheel
1. Park the machine on a level surface, lower the cutting units, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Block the wheels that are not removed with chocks to prevent the machine
from moving.
3. Loosen, but do not remove the 5 wheel-lug nuts that attach the wheel to
the machine.
IMPORTANT
Before lifting the machine with a jack, review and follow Jacking
Instructions (page 1–6) .
4. Lift the machine with a jack until the wheel to be removed is off the ground.
Support the machine with appropriate jack stands.
5. Remove the 5 wheel-lug nuts that attach the wheel to the machine, and
remove the wheel.
Installing the Wheel
1. Install the wheel to the machine with the 5 wheel-lug nuts.
2. Lower the machine to the ground.
WARNING
Failure to maintain proper torque could result in failure or loss of
wheel and may result in personal injury.
Maintain the proper torque of the wheel-lug nuts.
3. Torque the wheel-lug nuts evenly to 95 to 122 N∙m (70 to 90 ft-lb) in a
crossing pattern.
4. Check and adjust the tire pressures; refer to Specifications (page 8–2) .
Chassis: Service and Repairs Page 8–6 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C