Section 10: POTS Operation and Usage Tips
T
ieline
Page 80
T E C H N O L O G Y
Important Note:
This control does not affect the level of the transmitted or
received program audio. It only controls the monitoring of these sources in the
headphones.
10.15.
Routing POTS Voice Calls to a Codec’s Analog Outputs
It is possible to route POTS and GSM voice calls to a codec’s analog outputs by
pressing
SOFTKEY 1 Audio
and selecting [Route PhIn to CHOut] > [Enable].
The default setting is
Disable
.
This can also be configured using
Tool
Box
software via the
Inputs
tab, as
displayed in the following image.
Figure 26: Route Phone Input to Outputs Check-Box
Once this has been configured, analog audio is routed to the analog outputs
instead of the
Encoder/s
– allowing this audio to be used as an analog program,
foldback or IFB feed.
In this situation audio is deselected from the
Encoders
and is instead sent to
analog
CH1 & 2 Out.
The program matrix effectively looks like the one displayed
in the following image when the
Route Phone In to Out
check-box has a tick in it.
