Section 25: POTS Tab
T
ieline
Page 241
T E C H N O L O G Y
Connection Tip:
If you are connecting a POTS module to a new POTS G3 module, use the POTS
module in the local codec. This will allow you to renegotiate the connection
upwards seamlessly if required, without the delay of retraining.
25.2.
Select POTS Interface
Your codec is capable of using two POTS
connections. This drop-down menu allows the user
to select between two possible connections and in
turn configure both connections. To select the
POTS connection you want to configure, simply
click on the right-hand arrow, highlight the desired connection and click on it to
select it.
Please note: Depending on the codec you are using, this menu will display slightly
differently. The preceding image shows a
COMMANDER
G
3
codec with two
POTS modules installed. An
i
-
Mix
G
3
codec will display the on-board POTS
connection and a right-hand POTS module if this is installed.
25.3.
Operating Mode
This setting is the same setting as the setting in the
GSM
LL/GSM/USB-3G
Tab. If a selection is made in either menu
it will change in both menus. There are three operation
modes that include the following selections.
25.3.1.
POTS
Select this operation mode when connecting via a standard POTS
connection.
25.3.2.
GSM Landline
This function needs to be selected if the codec you are using is to dial via a
landline and will be communicating with another codec using a GSM cell-
phone. Only the landline-connected codec needs to select this function.
25.3.3.
Voice
Select this operation mode when connecting using a standard voice call. If
Voice
is selected then redundant settings in the
POTS
tab will be greyed out.
