Section 25: POTS Tab
T
ieline
Page 240
T E C H N O L O G Y
Section 25
Section 25.
POTS Tab
When you click on the
POTS
tab in the
Profile Editor
menu there are several settings
available for programming the function of your codec in POTS mode. (Please note:
Even if you don’t have
Tool
Box
software connected to your codec, these functions
are available by accessing your codec menu via
SOFTKEY 4 Menu
. Next select
Configuration
and select the POTS connection you wish to configure. Now scroll
through the menu and adjust the settings you wish to change. See the Configuration
menu diagram for details of this menu structure.)
Figure 75: The POTS Tab Page in the Profile Editor
25.1.
POTS and POTS G3 Module Differences
The new POTS G3 module dials a little differently to the original POTS module.
Please see the section in this manual titled POTS versus new POTS G3 Modules
for detailed information about using these modules, differences in connecting
and default connection bit rates.
Very Important Renegotiation Note:
After initially connecting, if you attempt to shift the connection bit-rate upwards
locally with a POTS G3 module, the codec will ‘retrain’ upwards, not renegotiate
like the original POTS modules. Retraining takes significantly longer than
renegotiation – up to 30 seconds.
