Section 9: Quick Start
T
ieline
Page 60
T E C H N O L O G Y
and a secondary activation menu will appear along the bottom of the
screen. You will see
CUE1
and
CUE2
above
HOTKEYS 2
and
3
. (Please
note that rack unit codecs and the TLG3 GUI rack mount codec control
software have dedicated
CUE
buttons so you will not need to do this).
Pressing the
CUE
key on either of the 2 microphone inputs will route audio
from these inputs to the off-air bi-directional communications channel only.
Audio being sent will be heard in the right side of both headphone outputs.
Communications audio will be displayed on
PPM 2
. To return to the main
menu hold down the
MS
for 2 seconds, or it will automatically return to the
main menu after two minutes. For more information on the
i
-Mix
G
3
phone coupler, please see the codec reference manual.
IP Warnings:
If you connect over IP and use auto jitter buffer then both codecs must
have firmware v.1.6.xx installed. Unless the remote codec has a public IP address
assigned to it and you know what the number is (or you are connecting using a SIP
server), you will always have to dial the public IP address of the studio from the field
codec. I.e. always dial from the field codec to the studio codec over the Internet.
If you are unable to achieve a connection using these instructions, please refer to the
relevant section of this reference manual for more detailed connection information. If
you connect with IP, 3GIP or SIP, please download the “IP and 3GIP Streaming
Reference Manual” from the
T
ieline
website at www.tieline.com .
If you continue to have difficulty connecting, contact
T
ieline
at [email protected] for
more assistance.
