Appendix 5: Compliances
T
ieline
T E C H N O L O G Y
Page 378
The Telephone Company may make changes in its facilities, equipment,
operations or procedures that could affect the operation of the equipment. If this
happens the Telephone Company will provide advance notice for you to make
the necessary modifications in order to maintain uninterrupted service.
If you experience problems with this equipment, contact TIELINE Pty Ltd, 25
Irvine Drive, Malaga. Western Australia, 6090. Ph +61 8 9249 6688 Fax +61 8
9249 6858 email [email protected] (web page www.tieline.com) for repair and
warranty information.
If the problem is causing harm to the telephone network, the Telephone
Company may request you remove the equipment from the network until the
problem is resolved.
No user serviceable parts are contained in this product. If damage or
malfunction occurs, contact TIELINE Pty Ltd for instructions on repair or return.
This equipment cannot be used on a telephone company provided coin service.
Connection to Party Line service is subject to state tariffs.
Appendix 5.3.
IC
NOTICE: The Industry of Canada label identifies certified equipment. This
certification means that the equipment meets certain telephone network
protective operational and safety requirements. The Department does not
guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local Telecommunications Company. The
equipment must also be installed using an acceptable method of connection. In
some cases the companies inside wiring associated with a single line individual
service may be extended by means of a certified connector assembly (telephone
extension cord). The customer should be aware that compliance with the above
conditions might not prevent degradation of the service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by TIELINE Pty Ltd. Any repairs or alterations
made by the user to this equipment, or equipment malfunctions may give the
telecommunications company cause to request the user disconnect the
equipment. Users should ensure for their own protection that the electrical
ground connections of the power utility, telephone lines and internal metallic
water pipe system, if present, are connected together. This precaution may be
particularly important in rural areas.
Appendix 5.4.
CE & CE Tick
This product has been extensively tested to ensure compliance with Australian “C
Tick” and European CE requirements.
Because high frequency circuits are used, it is possible that induced radiation may
enter the signal path. Care should be taken to avoid high levels of radio frequency
exposure to the unit as this may result in some distortion or failure of the audio
signal
