Section 17: Operation of your Codec
T
ieline
Page 104
T E C H N O L O G Y
The currently selected profile will have two arrows on either side of it, i.e.
→
Manual Default Mono
←
. If you wish to change the profile scroll the rotate the
MENU SELECTOR
until the square brackets surround the profile you want to
select and press it or press
SOFTKEY 4
to select the profile. Then press
SOFTKEY 2
to confirm the selection.
Very Important Connection Note:
Please ensure that you set both the local and remote codecs to operate using the
same algorithm – otherwise your codecs will not operate correctly.
If you are using manual default profiles, when the dialing codec calls the remote
codec, the dialing codec will automatically set both the profile and the default
algorithm on the remote codec to match the dialing codec’s setting.
In addition, it is very important to note that remote control of a codec is not
possible unless you are using either the
Music, Music Plus
or
Voice G3
algorithms.
Important Profile Note:
The profile on powering up can be set to your
preference via [Menu] > [Configuration] > [Advanced Menu] > [Powerup Profile].
This can also be configured via
Powerup Profile
within the
Global Settings
menu in
Tool
Box
software.
Connection Tip:
If a loaded profile has a connection or connections that are
not supported by the current hardware (i.e. it is a profile set for ISDN
connections but no ISDN modules are in the codec), the
LCD
won’t display any
connections but instead will display an error message indicating it is not
supported – either adjust the profile settings or install the correct module if this
occurs.