Thermo Scientific Dionex ICS-2000, Operator'S Manual

Page: 271 / 390

Setting Up the Eluent Generator
Doc. 031857-03 4/06
B-67
1. Disconnect the
TO INJ VALVE IN - P/ELUENT OUT
line from port
P
(
2
)
on the injection valve.
2. Use a 10-32 to 10-32 coupler (P/N 042627) to connect the yellow
0.5 mL/min, 7 MPa (1000 psi) backpressure coil (P/N 053765) to the
TO INJ VALVE IN - P/ELUENT OUT
line.
3. Connect a 10-32 to 1/4-28 coupler (P/N 042806) to the free end of the
backpressure coil.
4. Disconnect the
TO SRS/AES REGEN OUT
line from the suppressor
REGEN OUT
port.
5. Connect the
TO SRS/AES REGEN OUT
line to the 10-32 to 1/4-28
coupler (see Figure B-66 ).
NOTE The backpressure coil connection in Figure B-66 is
temporary; it is required only during the EPM and
EluGen cartridge conditioning procedure described
in the next section.
Figure B-66. Backpressure Coil Connections for Conditioning the
EluGen Cartridge and EPM with Carbonate/Bicarbonate Eluent
Backpressure
10-32 to
1/4-28
Coupler
TO INJ
VALVE IN - P/
ELUENT OUT
TO SRS/AES
REGEN OUT
10-32 to
10-32
Coupler
Coil