Thermo Scientific Dionex ICS-2000, Operator'S Manual

Page: 257 / 390

Setting Up the Eluent Generator
Doc. 031857-03 4/06
B-53
Items Required to Complete the Setup Procedure
The following items are required to setup the EluGen cartridge, EPM, and
EGC CO
3
Mixer. Except as noted, all items are supplied in the ICS-2000
Ship Kit (P/N 064375).
Item P/N Used To
EPM mounting bracket 063624 Mount the EPM on the EGC holder
35 cm (14 in) of black 0.25-mm
(0.010-in) ID PEEK tubing 064340 Lengthen the line between the EGC degas
eluent inlet and the EPM
ELUENT OUT
port
30 cm (12 in) of black 0.25-mm
(0.010-in) ID PEEK tubing 064334 Lengthen the line between the EluGen
cartridge outlet and the EPM
ELUENT IN
port
28 cm (11 in) of clear 1.58-mm
(0.062-in) ID Teflon tubing 064337 Lengthen the line between the EGC degas
regenerant inlet and the EPM
REGEN OUT
port
EluGen Cartridge Vent Line
Tubing Kit (supplied with the
cartridge) 063092 Vent the cartridge during operation
Yellow 0.5 mL/min, 7 MPa
(1000 psi) backpressure coil 053765 Provide backpressure during setup
procedures
EGC CO
3
Mixer mounting clips 063642 Install the mixer
Phillips head screwdriver
(not supplied) n/a Install the EGC CO
3
Mixer mounting clips
35 cm (14 in) of black 0.25-mm
(0.010-in) ID PEEK tubing 064346 Connect the EGC degas eluent outlet and the
EGC CO
3
Mixer inlet
60 cm (24 in) of black 0.25-mm
(0.010-in) ID PEEK tubing 064343 Connect the EGC CO
3
Mixer outlet to port P
( 2 ) on the injection valve
Temporary waste container
(beaker, bottle, etc.) (not supplied) n/a Collect waste during setup procedures
10-32 to 10-32 coupler
10-32 to 1/4-28 coupler 042627
042806 Complete the connections
10-32 fittings
10-32 ferrules 043275
043276 Complete the connections
1/8-in fittings
1/8-in ferrules 052267
048949 Complete the connections