sorin 75220, Operator'S Manual, Page: 127 / 304

Processing
X
TRA
Operator’s Manual
20077/021 US
5-45
“Send Output” Button
Touching the “Send Output” button sends case data to the destination selected with the
data destination menu.
If the printer is selected, this button prints general information about the case. To add additional
information to the printout, use the following two buttons:
“Add Bowl Tally” Button
Touch the “Add Bowl Tally” button to enable the inclusion of bowl tally data in printed
reports. When enabled, the button will appear inset and green. Touch the button a second
time to disable the inclusion of bowl tally data. Refer to “Bowl tally” on page 11-11 for a
list of information included in reports when the “Add Bowl Tally” button is enabled. This button is only
enabled if “Printer” is selected from the drop-down destination menu.
“Add Alarms & Mods” Button
Touch the “Add Alarms & Mods” button to enable the inclusion of event data (such as
alarms and modification of parameters which occurred during the case) in printed
reports. When enabled, the button will appear inset and green. Touch the button a
second time to disable the inclusion of event data. Refer to “Bowl tally” on page 11-11 for a list of
information included in reports when the “Add Alarms & Mods” button is enabled. This button is only
enabled if “Printer” is selected from the drop-down destination menu.
“ATS | SEQ” Selector Button
The “ATS | SEQ” Selector button is used to switch between viewing the data tallies for
ATS processing cycles and for whole-blood sequestration (PPP/PRP) processing cycles.
If only one type of cycle has been performed for the case being displayed, the “ATS |
SEQ” Selector button is disabled.
“Past Cases” Button
Touching the “Past Cases” button displays the Past Cases Screen (refer to “Past Cases
Screen” on page 5-52). This button is only available when processing is stopped, or from
the Setup Screen before a case has been started.
“Reopen Case” Button
When viewing a previously concluded case while processing is stopped, the “Reopen
Case” Button will be enabled. Touching the button will reopen the case for further
processing, appending tally data to the current case. Refer to “Selecting Past Cases” on
page 11-4.
Close button
Touching the Close button from any tab will close the Menu Screen and return to the active
Processing or Ready Screen.
Refer to
Chapter 11: Data Download Option
for complete instructions on exporting and printing the
data of current and past cases.