sorin 75220, Operator'S Manual, Page: 114 / 304

Processing
5-32
20077/021 US
X
TRA
Operator’s Manual
Manual
In Manual mode the operator has full control over each cycle and advances through the phases
manually using the phase buttons in the button bar of every Processing Screen (see Figures 5-30,
5-31, and 5-32). These phase buttons are also available while processing is paused in Automatic and 1
Touch modes (refer to “Pausing and Resuming the Cycle” on page 5-11 for a description of each phase
button).
The only ATS protocol which may be used in Manual mode is Pstd (and any user-defined protocols
derived from it).
In Manual mode, the Autostart and Continue automations are not available.
While Manual mode is active, “Manual” appears in the status area of every screen and phase buttons
(Fill, Wash, Spill, Empty) are always visible in the button bar of each processing screen.
Manual mode will not be available if disabled in the current configuration (refer to Chapter
8: Configuring Xtra
).
Figure 5-29 Ready Screen in Manual Mode
Figure 5-30 Fill Phase in Manual Mode