SignaMax 065-7434, Configuration Manual

Page: 370 / 669

2 SIGNAMAX LLC • www.signamax.eu
OSPF Basic Commands
OSPF commands can be classified to three types, including the
commands for configuring OSPF process, the commands for
configuring OSPF area, and the commands for configuring OSPF
interface.
C o m m a n d s f o r C o n f i g u r i n g O S P F Pr o c e s s
Command Description
Configuration
Mode
router ospf
process-id
[
vrf
vrfname
]
*Enable OSPF process or
enable OSPF process from
vrf. It is recommended that
one vrf is configured with
only one OSPF process. After
configuring the command,
switch to the OSPF route
configuration mode. config
network
network-id wildmask
area
area-id
*Specifies the range of the
interface addresses covered
by the OSPF . The interfaces
whose IP addresses are
within the address range are
added to the OSPF route
process
and the route
information of the interfaces
are managed by OSPF.
config-ospf
clear ip ospf
[
process-id
]
process |
route | redistribution | statistics
[
ifname
]
| neighbor
[
if-addr
] [
nbr-id
]
Re-start OSPF process; re-
calculate the OSPF route; re-
distribute the outer routes;
clear
the statistics
information of the OSPF
process; reset the neighbor
of one interface address.
enable
auto-cost reference-bandwidth
ref-bandwidth
Set the bandwidth to
calculate the cost (it can be
selected from 1-4294967).
The default value is 100.
config-ospf
capability opaque
Support sending and
receiving transparent LSA.
config-ospf
compatible rfc1583
Whether ASBR or the priority
rule when selecting outer
routes is compatible with
RFC1583 config-ospf
default-information
originate
[
always
|
metric
{
metric-
value
} |
metric-type
{
type-value
} |
route-map
{
map-name
} ]
The AS edge route brings the
default route to the OSPF
route domain. The cost, cost
type and route mapping can
be specified. config-ospf
default-metric
metric-value
Specify the cost of all re-
config-ospf