SignaMax 065-7434, Configuration Manual

Page: 344 / 669

344 SIGNAMAX LLC • www.signamax.eu
or notified routes. The no format of the command is used to cancel the RIP route filtering.
distribute-list { access-list-name | prefix prefix-list-name } { in | out } [ interface ]
no distribute-list { access-list-name | prefix prefix-list-name } { in | out } [ interface ]
Syntax Description
access-list-name To configure the standard access list name of the RIP route filtering. Here, only
the standard access list is supported.
prefix-list-name
To configure the prefix list name of the RIP route filtering
in
To configure filtering the learned routes
out
To configure filtering the notified routes
interface
To configure the interface using the filtering configuration; when the interface is
not configured, filter all routes.
【
Default status
】
Do not filter routes.
maximum-paths
This command is used to configure the maximum next hops of the RIP payload balance. When
the next hops of the learned routes exceeds the maximum route next hops, the learned new
next hops replace the next hops that consume more than a half valid time.
The no format of the command is used to recover the default value of the maximum next hops
of the RIP payload balance.
maximum-paths max-number
no maximum-paths [ max-number ]
Syntax Description
max-number To configure the maximum next hops of the RIP payload balance; the value
range is 1-6.
【
Default status
】
max-number: 4
maximum-prefix
This command is used to configure the maximum number of the routes in the RIP route
database and the alarm percentage. The command can only block learning more routes, but
cannot delete the original learned routes and limit the routes generated by the switch (such as
the re-distributed routes). The no format of the command is used to cancel the limitation for
the maximum number.
maximum-prefix
max-number [warning-percent]
no maximum-prefix
Syntax Description