Symbols for enabled operations:
● Green check mark: The OS operator can control this parameter
● Gray check mark: the OS operator cannot control this parameter at this time due to the
process
● Red cross: The OS operator cannot control this parameter due to the configured AS
operating permissions (
OS_Perm
or
OS1Perm
)
The following enabled operationss are shown here:
General enabled operationss:
● "Reset": You can reset the peak value of the gradient.
● "On": You can switch to "On" mode.
● "Out of service": You can switch to "Out of service" mode.
● "Out of service": You can switch to "Out of service" mode.
● "Local operator authorization": Use the button to change to the standard view of
the
OpStations
block. For more information, refer to the "Operator authorizations" section
in the APL Online Help.
(3) Jump button for switching to the standard view of any faceplate
Use this navigation button to open the standard view of a block configured in the engineering
system. The visibility of this navigation button depends on the configuration in the engineering
system (ES).
You can find more information on this in the section "Opening additional faceplates" in the APL
Online Help.
17.1.9.6
Block icons for SitrLuHA
A variety of block icons is available with the following functions:
● Process tag type
● Limits (high/low)
● Violation of alarm and warning limits as well as the control system fault
CSF
● Operating modes
● Signal status, release for maintenance
● Memo display
● Process value (
PV_In
, 4 to 20 mA signal)
SITRANS LU HART
17.1 SitrLuHA
SITRANS Library for PCS 7
810
Function Manual, 05/2019, A5E35351976-11
Summary of Contents for SITRANS PCS 7
Page 12: ...Table of contents SITRANS Library for PCS 7 12 Function Manual 05 2019 A5E35351976 11 ...
Page 418: ...SITRANS P 10 2 SitraPDr SITRANS Library for PCS 7 418 Function Manual 05 2019 A5E35351976 11 ...
Page 850: ...Index SITRANS Library for PCS 7 850 Function Manual 05 2019 A5E35351976 11 ...