Siemens SITRANS PCS 7, Function Manual, Page: 233 / 850

Parameter Description Type Default
RdyToReset 1 = Ready for reset via RstLi input
or commands in "automatic mode"
STRUCT
Value: BOOL
ST: BYTE -
0
16#80
RdyToStart 1 = Active start readiness STRUCT
Value: BOOL
ST: BYTE -
0
16#80
ST_Worst Worst signal status BYTE 16#80
Status1 Status word 1 DWORD 16#00000000
Status2 Status word 2 DWORD 16#00000000
Status3 Status word 3 DWORD 16#00000000
Status4 Status word 4 DWORD 16#00000000
Status5 Status word 5 DWORD 16#00000000
SumMsgAct 1 = Group message active STRUCT
Value: BOOL
ST: BYTE -
0
16#80
WarnAct 1 = Prewarning for control valve
movement away from neutral po‐
sition active (WarnTiAut and
WarnTiMan parameters)
STRUCT
Value: BOOL
ST: BYTE -
0
16#80
7.1.7 Template of SipPS2HA
Three different templates are available to connect the SIPART PS2 HART to PCS 7 . Each
template is designed for the maximum configuration so you may need to delete some unused
functions.
Before copying the templates into a project, you must first copy the standard PCS 7 blocks from
the APL into the SITRANS library because they are not supplied due to licensing reasons.
These are the driver blocks Or08, SelST16, Pcs7InDi, Pcs7AnIn, Pcs7AnOu, FbAnIn, FbAnOu
and the Intlk02 block.
SIPART PS2 HART 0/4 to 20 mA
This template is used to connect a SIPART PS2 via a 0 to 20 mA or 4 to 20 mA signal without
HART.
The driver blocks BE1/BE2, Rbk (0/4 bis 20 mA), MV, A1Act/A2Act and AModF must either be
interconnected to the corresponding I/O address or deleted if their functionality is not needed.
Optionally, the Permit, Interlock and Protect blocks can be interconnected with other blocks.
SIPART PS2 HART
7.1 SipPS2HA
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11
233