Siemens SITRANS PCS 7, Function Manual

Page: 451 / 850

Note
If the
Feature
bit 7 (synchronize alarm configuration with module) is set, the measuring range
limits available in the module are written to the corresponding inputs when reading the
configuration data.
(2) Totalizer limits
In this area, you can enter the limits for the totalizer. You can change the following limits:
● "H alarm": High alarm
● "H warning": High warning
● "Hysteresis"
● "L warning": Low warning
● "L alarm": Low alarm
Note
If the
Feature
bit 7 (synchronize alarm configuration with module) is set, the measuring range
limits available in the module are written to the corresponding inputs when reading the
configuration data.
If a totalizer is not configured, its limits are switched to invisible.
(3) Gradient limits
You can enter gradient limits in this area. Refer to the "Changing values" section in the APL
online Help.
You can change the following limits:
● "H alarm ⇑": Gradient for the upper gradient for positive changes
● "H alarm ⇓": Gradient for the upper rate of rise for negative changes
● "L alarm ⇑⇓": Gradient for the lower rate of rise (absolute)
(4) Enabled operations
This area shows all operations for which special operator authorizations are assigned. They
depend on the configuration in the engineering system (ES) that applies to this block.
Symbols for enabled operations:
● Green check mark: The OS operator can control this parameter
● Gray check mark: The OS operator cannot control this parameter at this time due to the
process
● Red cross: The OS operator cannot control this parameter due to the configured AS
operator authorizations (
OS_Perm
or
OS1Perm
)
SITRANS P PA
11.1 SitrP_PA
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11
451