118A2221A - AN363632996019en-ZA0101 | 1
© Danfoss | DCS (CC) | 2020.12
A
B
D
E
G
C
F
IP 54
(2) R134a
R513A
(2) 23 bar
(2) 5 bar
OP-MPXM034MLP00G
114X4261
Refrigerant (1) R404A R507 R448A/R449A
R407A/R407F/R452A
Voltage 230 V ~ 1N ~ 50Hz
M.W.P. HP (1) 28 bar
M.W.P. LP (1) 7 bar
Serial No. 123456CG2816
xxxxxxxxxxxxxx
LRA 60 A MCC 19 A
11
8U
XXXXXX
MADE IN INDIA
Danfoss A/S, 6430 Nordborg, Denmark
OIL INSIDE POE 46
EAN No.
Application MBP
Optyma
™
Plus
OP-LPQM, OP-MPXM
A
: Model
B
: Code number
C
: Application, Protection
D
: Refrigerant
E
: Housing Service Pressure (Maximum
working pressure)
F
: Supply voltage, Locked Rotor Ampere,
Maximum Current Consumption
G
: Serial Number and bar code
Name plate
Compressor running
Crankcase heater on
Fan running
Temperature value for suction pressure.
Push lower button to switch to tempera-
ture value for condensing pressure
Picture 3 : Electronic controller display
W
Q
R
X
Z
Y
Q
: Air in
R
: Air out
Unit
W
[mm]
X
[mm]
Y
[mm]
Z
[mm]
Housing 4
(Code n° 114X34-- or 114X44--)
250 900 700 700
Picture 1 : Minimum mounting distances
The condensing unit must only be used for
its designed purpose(s) and within its scope of
application.
Under all circumstances, the EN378 (or
other applicable local safety regulation)
requirements must be fulfilled.
The condensing unit is delivered under nitro-
gen gas pressure (1 bar) and hence it cannot
be connected as it is; refer to the «installation»
section for further details.
The condensing unit must be handled with cau-
tion in the vertical position (maximum offset
from the vertical : 15°)
Installation and servicing of the condensing
units by qualified personnel only.
Follow these instructions and sound
refrigeration engineering practice relating to
installation, commissioning, maintenance and
service.
Picture 4 : Normal wiring
Picture 5 : Temporary wiring
T
: Mounting brackets for stacked mounting (not supplied)
U
: M8 bolts for stacked mounting (supplied)
V
: Mounting bolts (not supplied)
T
U
U
V
V
Picture 2 : Stacked mounting
