RMG ERZ2000-NG, Operating Manual

Page: 81 / 454

2 Introduction
Manual ERZ 2000-NG · EN07 · 2019, May 13th
71
Those accustomed to operating an ERZ2000 with device buttons have the possibility
of also operating the ERZ2000-NG in this manner with this screen. The 4-line display
of the ERZ2000 is also shown here. If operation via this "4 Lines" menu is selected,
refer to the ERZ2000 manual in case of any questions. This manual can be down-
loaded as necessary via the homepage
www.rmg.com .
You can switch back and forth between the column selection menu and the matrix
with the "*" button (selection). The arrow keys enable navigation in the menu as well
as the matrix.
2.5.5 Functions
Figure 57: "Drag pointer" sub-menu under "Functions"
The "Functions" menu opens 5 additional sub-menus, which are listed below.
2.5.5.1 Drag pointer
The absolute minimum and maximum values for the measurements since the last
restart or since the last resetting of the drag pointer are shown here. The function is
defined in coordinates
XX31 Min. drag pointer and XX32 Max. drag pointer . In the
process, XX stands for the values and parameters for which this function is available.
These values specified for the "
drag pointer
" are deleted with "Reset" and then the
set to the current measurement. The display is shown in
Figure 57: "Drag pointer"
sub-menu under "Functions"
. The drag pointers can also be reset globally in the EM
erasing procedure menu.
Depending on the mode selected in
EI27 Drag indicator mode , the drag pointer is
calulated from the conversion of the used measurement or the original measurement.