RMG ERZ2000-NG, Operating Manual

Page: 376 / 454

Appendix
Manual ERZ 2000-NG · EN07 · 2019, May 13th
366
You should have received the software from the RMG service department.
The following required files should be loaded to the SD card to update the soft-
ware:
md5.txt
version.txt
and the subdirectories
\Bin
\ERZ2000NG
\HTMLS
\tools
The subdirectory \ERZ2000NG does not contain any files for archive content and
parameters. Therefore, an existing file can be overwritten without loss of parame-
ters or archives.
x
Re-insert the SD card (push it in the slot until it engages).
x
Re-install the front panel (= reverse order of removal of the front panel).
x
Switch on the ERZ2000-NG.
Enter activation key
Enter the activation key for the new software, which is provided under coordinate
EJ10 Enable . The activation key and the target CRC of the WinCe kernel can be
found in the approval documentation under "Identification".
Checking BIOS
After the update, a new BIOS on the SD card is not automatically active. There-
fore, check the device BIOS to determine whether it should be updated and re-
installed if applicable; contact RMG customer service for information about the
latest BIOS version.
B.4 Installing BIOS
Open the calibration switch
Prevent automatic resetting
x
Activate coordinate ED05 Service mode ("yes") in order to prevent an auto-
matic device reset (watchdog) during subsequent steps.