RMG ERZ2000-NG, Operating Manual, Page: 79 / 454

2 Introduction
Manual ERZ 2000-NG · EN07 · 2019, May 13th
69
the matrix element "Kernel CRC EJ21". The setpoint is displayed in the matrix ele-
ment "Kernel CRC, EJ22" for comparison.
In order to adopt the newly calculated values according to this service function, an
additional restart is necessary, which can be initiated via the service function "Exit
program" with "Execute" (or by disconnecting the power supply).
Note
Attention:
In menu E Mode, ED Access to parameters, coordinate ED05 Service mode
must be set to the default value "no".
The setting "yes" is reserved for the service department when settings
should be made in WinCE.
After a restart, the calibration official checks the CRC; if the check is successful, the
calibration switch is closed and the device is sealed by the calibration official. Then
the final setup of the ERZ2000-NG can take place. In the process, the network set-
tings and time zone are stored in the device. The device is ready for operation when
all necessary settings have been made.
Figure 54: "Touch calibrate" service menu / sub-program
If a blur occurs on contact of the stylus with the touchscreen, calibration can take
place in the "Touch calibrate" menu item under functions. After the function starts a
series of crosses that must be touched in the center is displayed. This calibration can
take place at any time. The
contrast can also be changed in the service menu at any
time. The touch calibration can also be activated by pressing the home button on the
overview page and drawing a line covering about 1/3 of the screen width. Then the
touch calibration opens automatically.