RMG ERZ2000-NG, Operating Manual

Page: 185 / 454

5 Transmitters
Manual ERZ 2000-NG · EN07 · 2019, May 13th
175
The lower part provides a pre-selection of various pressure transducers approved for
custody transfer applications, which can be selected. If you select one of these pres-
sure transducers (e.g. "3051S1CA2 10 bar"), a pre-setting is applied, wherein the key
data is already transferred. All data that is recommended has a bright yellow-green
background.
This can be seen in
Figure 120: Pre-selection of a pressure transmitter
with an ab-
breviated representation of
Figure 119: Menu AB Absolute pressure
.
Figure 120: Pre-selection of a pressure transmitter
With "enter" (below the table to the left, see
Figure 119: Menu AB Absolute pres-
sure
), these values are specified in the ERZ2000-NG. The manufacturer and trans-
mitter type and pressure range are adopted. The operating mode is defined with the
transmitter type (in this case, measurement value = source value), the default value,
the alarm and warning limits are pre-adjusted, transfer via Hart protocol is the pre-
setting here. As an additional pre-setting, a current input combined with HART func-
tion is selected as source.
Note
If the transmitter is operated as a transmitter, it must be ensured that the
transmitter feed is switched on in the assigned menu of the current input.
Note
Please check these pre-settings!
They must also be adapted to your application as necessary.
Please fill in the missing data as necessary, such as the serial number of the
transmitter, etc. This type plate data of the transmitters must always be entered
at the end of the function block with the transmitter data.
Not all missing specifications are required.