Ricoh LP124w, Software Manual

Page: 263 / 376

Remote Maintenance by telnet
249
6
wiconfig
Use the “wiconfig” command to make settings for IEEE 802.11b.
❖
View settings
msh> wiconfig
❖
View IEEE 802.11b settings
msh> wiconfig cardinfo
• If IEEE 802.11b is not working correctly, its information is not displayed.
❖
Configuration
msh> wiconfig "parameter"
Parameter Value configured
mode {ap|ad-
hoc|802.11adhoc}
You can set the infrastructure mode (ap) , the 802.11 ad
hoc mode (802.11adhoc), or the ad hoc mode (adhoc).
The default is ad hoc mode.
ssid "ID value"
You can make settings for the SSID in the infrastructure
mode.
Usable characters are ASCII 0x20-0x7e (32 bytes).
An SSID value is set automatically to the nearest access
point if no setting is made.
If no setting is made for the ad hoc mode, the same value
as for the infrastructure mode or an ASSID value is auto-
matically set. The default is blank.
channel frequency
"channel no."
You can enable or disable the WEP function. To enable
the WEP function, specify
[ on ] ; to disable it, specify [ off ] .
To start the WEP function, enter the correct WEP key. The
default is “11”.
key "key value" val
{1|2|3|4}
You can specify the WEP key when entering in hexadeci-
mal.
With a 64-bit WEP, you can use 10 digit hexadecimals.
With a 128-bit WEP, you can use 26 digit hexadecimals.
Up to four WEP keys can be registered. Specify the num-
ber to be registered with “val”.
When a WEP is specified by key, the WEP specified by
key phrase is overwritten.
To use this function, set the same key number and WEP
key for all ports that transmit data to each other. Put “0x”
on the front of WEP key.
You can omit the numbers with “val”. The key number is
set to 1 when making these omissions. The default is blank.