Ricoh LP1136n, Manual

Page: 90 / 574

Configuring WPA (802.1X)
WPA (802.1X) uses an authentication server to provide greatly enhanced security compared to WPA-PSK.
WPA (802.1X) can be configured using Web Image Monitor's administrator mode.
You can select four types of EAP authentication method: EAP-TLS, LEAP, EAP-TTLS, and PEAP. Note that
each EAP authentication method has different configuration settings and authentication procedures.
Types and requirements of certificates are as follows:
If a certificate is required, configure all settings after installing the certificate.
EAP Types Requiring a "Site Certificate"
EAP-TLS, EAP-TTLS, PEAP (Necessary except LEAP)
EAP Types Requiring a "Site Certificate" and/or a "Device Certificate"
EAP-TLS, PEAP (Phase 2 is for TLS only)
• To set WPA (802.1X), you must enable SSL.
• To set WPA (802.1X), you must use Web Image Monitor.
• "Protection Using Encryption", Software Guide.
• "Using Web Image Monitor", Software Guide.
Installing a Site Certificate
1. Access the authentication server and obtain the "CA Certificate".
Methods of obtaining certificates differ according to the operating system you are using.
2. Start your Web browser.
For details about the login user name and password, consult your administrator.
3. Enter "http://(printer's address)/" in the address bar of a Web browser.
4. Enter your user name and password, and then click [Login].
5. Click [Configuration].
6. Click [Site Certificate] in "Security".
7. Click [Browse] on [Site Certificate to Import], and then select the "CA Certificate" you
obtained.
8. Click [Import].
4. Configuration
70
4