OmniTek OTR 1001, User Manual

Page: 242 / 390

OmniTek OTR 1001 User Guide, v3.1 N-4
Line-Based
When the Line-Based option is cleared , both the line count shown on the upper line and the
pixel count shown on the lower line point in the same direction and the total delay is the sum of
the number of lines and the number of pixels. When
Line-Based is ticked , the line count is given
to the nearest whole number of lines and the pixel count should either be added to the line count
if the two meters point in the same direction or subtracted from the line count if the meters point
in opposite directions.
Detailed View
When the Detailed View option is ticked, the display switches to additionally showing the total
offset measured in seconds.
Figure N-4: Detailed version of the Reference Timing display
Invert option
Switches the third comparison between showing how much the input listed below the graph is in
advance/delayed relative to the one listed above and expressing this comparison the other way
round.
Save Offset
Saves the current delays as a set of reference values (until the system is reset/powered down).
Rel to Offset/Rel. to Analog
Selecting Rel to Offset switches the display from showing timings relative to the analog
reference to showing these timings relative to the currently saved offsets (see ‘Save Offset’
above). Selecting
Rel to Analog switches the display back to showing timings relative to the
analog reference.