OmniTek OTR 1001, User Manual

Page: 151 / 390

OmniTek OTR 1001 User Guide, v3.1 I-27
Display Properties
Details of the comparison made are set through options offered both on the Button Bar and in the
Properties control (Control Panel: press PROPS to display).
Properties Control
Figure I-21: Chroma Sabre Properties.
Button Bar
Capture Reference
(See Section I.8 ‘Single Camera Alignment’, above)
Alignment Sources (not offered in PQA mode)
Where the VIEW_3D option is installed and 3D Monitoring is enabled, this option selects
between comparing a Right-eye image against the corresponding Left-eye image (
Right vs Left )
and between comparing the image on Input 1 against a previously captured reference image ( In1
vs Ref ). When the VIEW_3D option is not installed or 3D Monitoring is not enabled, the choice
is between the image on Input 2 against the image on Input 1 ( In2 vs In1 ) and the image on
Input 1 against the reference image ( In1 vs Ref ).
Note: The In1 vs Ref option requires Analyser 1 to take its source from SDI Input 1 (or Eye
Input 1 if installed) and Analyser 2 to take its source from the built-in generator. If necessary, the
OTR will automatically re-assign the Analyser sources. Where this happens, the views displayed
in other tiles will also reflect the inputs that are now selected.
Scene Type (not offered in PQA mode)
This option selects the point matching algorithm to use from between the algorithm appropriate
to a
3D Scene and one appropriate to a Test Chart .