OmniTek OTR 1001, User Manual

Page: 148 / 390

OmniTek OTR 1001 User Guide, v3.1 I-24
Camera Pair Alignment
Basic Alignment (3D not enabled)
Control Panel Mouse & Keyboard
To align two cameras :
1. Feed the input from one camera into Input 1, and the input from the other camera into
Input 2.
2. Set up the camera(s) to focus on a Test Chart.
3. Call up the 3D Meters display.
4. Set the Scene Type option to Test chart
5. Set the Alignment Source to In2 vs In1 .
6. Adjust the set-up of the cameras to bring the values shown to zero or 1 as appropriate.
Aligning 3D Cameras
Control Panel Mouse & Keyboard
To align cameras producing Stereo 3D video:
1. Call up the System page of the Config window and check the set-up details recorded in the
3D Settings section. (For further information, see Section I.2)
2. Check that the Auto Gain Control and Auto correct Vertical Disparity options are ticked.
Note: The Colour Gain and the Vertical Disparity reported within the 3D Meters display
show the values prior to any correction that is applied to enhance point-matching between
the images.
3.
Feed the input from the ‘Left-eye’ camera into the port selected for Left-eye input, and the
input from the ‘Right-eye’ camera into the port selected for Right-eye input.
4. Set up the camera(s) to capture the selected scene.
5. Call up the 3D Meters display.
7. Set the Scene Type option to 3D Scene
8. Set the Alignment Source to Right vs Left
9. Adjust the set-up of the cameras to bring the values shown to zero or 1 as appropriate.