OmniTek OTR 1001, User Manual

Page: 127 / 390

OmniTek OTR 1001 User Guide, v3.1 I-3
I.2 Enabling 3D Monitoring and Camera Alignment
Before any of the 3D or Camera Alignment facilities described in this guide can be made
available:
3D Monitoring and Camera Alignment need to be enabled for the machine as a whole,
and
The format in which the S3D video is delivered needs to be defined.
These actions use the 3D Settings section of the System page of the Config window (the other
settings of which are described in Section T.4).
Figure I-1: 3D Settings section of the System page of the Config window.
While 3D Monitoring and Camera Alignment are enabled, the OTR’s Capture facilities are
disabled. However, the live input received on either input can still be passed through to the SDI
outputs (as described in Section P.4). There is also the option to pass-through the signals on both
inputs.
The steps used to enable 3D Monitoring and Camera Alignment are given below, along with the
steps used to disable these facilities (and re-enable the Capture facilities).
Control Panel Mouse & Keyboard
To enable 3D Monitoring and/or Camera Alignment:
1. Call up the System page of the Config window.
2. Tick Allow 3D Monitoring within the set of 3D Settings on that page.
To disable 3D Monitoring and/or Camera Alignment:
1. Call up the System page of the Config window.
2. Clear the tick beside Allow 3D Monitoring within the set of 3D Settings on that page.