OmniTek OTR 1001, User Manual

Page: 153 / 390

OmniTek OTR 1001 User Guide, v3.1 I-29
Configuration Issues
The following settings are needed on the System page of
the Config window:
Allow 3D Monitoring should be ticked
The port or ports on the OTR into which the images
are to be fed need to be set as the sources for
Analyser 1 and/or Analyser 2 as appropriate. For
details, see Section T.4.
For Stereo 3D video, the Channel Sources should
be set to show how the Left-eye and Right-eye
images are provided (see Section I.2).
Also for Stereo 3D video, the Camera Flip options
should be set to specify whether either image is
flipped either horizontally or vertically.
For further information, see Section I.4.
Note: The easiest way to check the Channel Assignment is
to look at one of the Depth displays described in Sections
I.5 –I.7.
Display Properties
The characteristics of the Waveform tile display are set by
the tile’s Properties (
shown right ) . The properties that
specifically apply to its ‘3D View’ are described below. The
other more general settings are described in Section E.3.
Note:
The following ‘3D View’ settings may only be
accessed through the Properties control. There are no
shortcuts for these settings on the Button Bar.
3D View
Tick this option to show the combined waveform. Clear the
selection to return to the single-input version of the display.
Checkerboard Size
Use this option to set the number of elements to each
waveform from a choice of 16, 32, 48, 64, 128 or 256.
Figure I-23: Waveform Properties
for Stereo 3D.