NPM PCL6113, User Manual

Page: 33 / 131

- 27 -
7-3. Control command
Set various controls, such as the reset counter.
The procedures for writing are the same as the operation commands.
7-3-1. Software reset command
Used to reset this LSI.
COMB0 Symbol Description
04h SRST Software reset. (Same function as making the terminal LOW.)
7-3-2. Counter reset command
Reset counters to zero.
COMB0 Symbol Description
20h CUN1R Reset COUNTER1.
21h CUN2R Reset COUNTER2.
7-3-3. ERC output control command
Control the ERC signal using commands.
COMB0 Symbol Description
24h ERCOUT Outputs the ERC signal.
25h ERCRST Resets the output when the ERC signal output is specified to a level type output.
7-3-4. Pre-register control command
Cancel the pre-register settings.
See section "8-2. Pre-register" in this manual for details about the pre-register.
COMB0 Symbol Description
26h PRECAN Cancel the operation pre-register.
7-3-5. PCS input command
Entering this command has the same results as inputting a signal on the PCS terminal.
COMB0 Symbol Description
28h STAON Alternative to a PCS terminal input.
7-3-6. LTCH input (counter latch) command
Entering this command has the same result as inputting a signal on the LTC terminal.
COMB0 Symbol Description
29h LTCH Alternative to an LTC (latch counter) terminal input.