NF KP3000GS, Instruction Manual

Page: 27 / 279

2. Preparation before Use
PROGRAMMABLE AC/DC POWER SOURCE 8
 Outdoors, place exposed to direct sunlight, or place near fire or heat source

This may reduce the performance, or cause failure.
 Place exposed to corrosive gas or water, or humid place

This may cause corrode or failure.
 Place exposed to briny air

This may cause salt damage.
 Place near electromagnetic field source, high-voltage equipment, or power line

This may cause malfunction.
 Place of frequent vibration

This may cause malfunction or failure.
 Dusty place

This may cause failure. Especially do not install the product in a place with conductive
dust.
 Electromagnetic emissions from this product may interfere with reception of radio and
television broadcasts. Unless the user takes special measures to reduce electromagnetic
emissions, using this product in a residential area must be avoided.
2.3 Cautions during Moving and Transportation
Follow the instructions below when moving or transporting this product.

Remove all wirings connected to this product.
 Before removing the wiring, be sure to turn off this product to cut the power from the
distribution board. Otherwise, an electric shock might occur.
 Check before movement and transportation
 Check the mass before moving the product (Table 2-3).
 Moving with casters
The casters attached to this product are intended for use to move the product on a horizontal surface.
To move the product on a sloped or uneven surface, licensed personnel should move it by operating
a lifting machine or crane instead of the casters.
 As this product is heavy, whenever it is moved, at least two people are required to move it.
 Move the Adjuster Foot up enough from the floor by using a spanner (19 mm diameter). You
can move the Adjuster Foot up by turning it counterclockwise as viewed from above.
WARNING