NF KP3000GS, Instruction Manual

Page: 109 / 279

4. Advanced Operation
PROGRAMMABLE AC/DC POWER SOURCE 90
 Relationship between each step and settable Step parameters
定常
1
移行 1 異常 移行 2 定常 2
T1 T2 T3 T4 T5
S1
S2 S4
S3 S5
トリガ出力
同期出力
V1, F1
V3, F3
V1, F1
電圧・周波数は
正常
1 と同じ
Voltage and
frequency are
same as
Normal 1
Trigger output
Sync output
Normal1 Normal2 Abnormal Trans1 Trans2
Figure 4-11 Simulation Function Steps
Table 4-5 Simulation Function Steps and Settable Step Parameters
Step Initial Normal 1 Trans 1 Abnormal Trans 2 Normal 2
Step time — T1 T2 T3 T4 T5
AC voltage V0 V1 — V3 — —(=V1)
Frequency F0 F1 — F3 — —(=F1)
Start phase
ON/OFF
P0
ON/OFF
P1
—
ON/OFF
P3
—
ON/OFF
P5
Stop Phase
ON/OFF
Q0
ON/OFF
Q1
—
ON/OFF
Q3
—
ON/OFF
Q5
Trigger output — ON/OFF ON/OFF ON/OFF ON/OFF ON/OFF
Sync code
output
S0 S1 S2 S3 S4 S5
Note: "—" means that this parameter cannot be set.
 Start phase (Start Phs)
ON or OFF can be selected for the start phase. When ON is selected, the step starts at the specified
start phase. When OFF is selected, the step starts at the phase in which the previous step ended.
When selecting ON, a numerical entry box in which you can specify the start phase opens.
The start phase can be set at the Normal 1, Normal 2, and Abnormal steps. For other steps, the start
phase is fixed to OFF and cannot be specified.
 Stop phase (Stop Phs)
ON or OFF can be selected for the stop phase. When ON is selected, the step ends at the specified
stop phase. If the phase is not the specified stop phase after the Step Time elapsed, the execution
continues the output of that step until reaching the specified Stop Phase, then performs the next step.
When OFF is selected, the step transitions to the next step when the Step Time has elapsed
regardless of the phase. When selecting ON, a numerical entry box in which you can specify the stop