NF KP3000GS, Instruction Manual

Page: 211 / 279

6. Remote Control
PROGRAMMABLE AC/DC POWER SOURCE 192
5. Use a commercially available USB cable (Type A to B) to connect this product to the computer.
USB connector is available on the rear of this product.
--------
Notes ------------------------------------------------------------------------------------------------------------
 Avoid use in a place under electrically noisy environment.
 It is recommended to use a fully-shielded, short cable.
 The use of USB hub may cause the product not to communicate properly.
-----------------------------------------------------------------------------------------------------------------------------
 About USB ID
Used for a system connected with multiple KP3000GS programmable AC/DC power sources
through USB, to enable the application identify each source. The USB ID is represented in the
following format.
USB0::[Vendor number]::[Product number]::[Serial number]::INSTR
Vendor number: Fixed to 3402 (0x0D4A)
Product number: Fixed to 33 (0x0021)
Serial number: A unique number (serial number) has been set for each product.
6.1.2 RS232
For the interface specifications, see 10.27 .
 Operation procedure
1. Press the MENU key to move to the root menu, then select [System]. The system setting
window opens.