NF KP3000GS, Instruction Manual

Page: 241 / 279

9. Maintenance
PROGRAMMABLE AC/DC POWER SOURCE 222
4. Remove the air filters from the back of each front grill. Be careful with the small claws on the
front grill that hold the air filters.
5. Rinse the removed air filters with water to remove dirt and clog. Dry them completely.
6. Remount them in reverse order of steps 1 to 5.
 While removing the air filters and the front grill, do not supply the power from the distribution
board. Otherwise, an electric shock might occur.
9.3 Storage, Repackaging, Transportation
This product shall be stored in a location that satisfies the installation conditions (see 2.2 ).
 Storage when unused for a long time
 Remove the power cable from the distribution board and the product.
 Store the product in a place with no falling object or dust. If it may be covered with dust, put
the cover, such as cloth and polyethylene sheet, on it.
 Avoid a place exposed to rapid temperature change or direct sunlight. Store it under a normal
temperature environment wherever possible. For the storage condition, see
10.31 .
 Repackaging and transportation
Follow the instructions below when repackaging the product due to transfer or repair.
 In order for the main unit to be sufficiently protected from impact during transportation, pack
it with a shock absorber such as AirCap.
 When requesting transportation, instruct the carrier that this product is a precision instrument.
 Be sure to include the instruction manual at transportation.
WARNING