NF KP3000GS, Instruction Manual

Page: 81 / 279

4. Advanced Operation
PROGRAMMABLE AC/DC POWER SOURCE 62
4.2.2 Parameters of Sequence Function
Table 4-2 shows the parameters of Sequence function. The common parameters are common to one
sequence. In Sequence function, signal source is fixed to INT. In each step, set the step-control
parameter and the intra-Step parameter. As for intra-Step parameter, the item and range that can be
set differ depending on the output range (100 V/200 V range) and output mode
(AC-INT/ACDC-INT/DC-INT) as in the case of Continuous function. This section describes
intra-Step parameters and step-control parameters separately.
Table 4-2 Parameters of Sequence Function
Common
parameter
Step-control parameter Intra-Step parameter
Output range
AC/DC mode Step Time
Jump-to step
Jump count (1 to 9999, or infinite)
Branch step
Step termination
Step sync code output (2bit)
Start Phase
Stop Phase
Trigger output Frequency
Waveform
AC voltage
DC voltage
 Frequency (Freq), waveform (Wave), AC voltage (ACV), DC voltage (DCV)
The setting for the output of each step. Phase angle can also be set per step.
 Step Time (Step Time)
Set the output time of that step. Unit can be selected from [s] or [ms].
 Jump-to step (Jump To)
When selected, the destination step of the jump at the end of the step can be specified. By specifying
the Jump count ([Jump Cnt]), you can set up a loop to repeat the same step. After jumping for the
times specified for one sequence, the action at the end of step follows the step termination setting.
If Jump-to is set to off, the action at the end of step follows the step termination setting.
--------
Notes ------------------------------------------------------------------------------------------------------------
 When the step termination is set as [Hold], the hold status is enabled before the jump.
-----------------------------------------------------------------------------------------------------------------------------