NF KP3000GS, Instruction Manual

Page: 107 / 279

4. Advanced Operation
PROGRAMMABLE AC/DC POWER SOURCE 88
 Sequence Control View (output on state/sequence stopped)
Figure 4-10 Sequence Control View (Output On State/Sequence Stopped)
4.3 Using Power Fluctuation Testing (Simulation) Function
4.3.1 Basics
The Power fluctuation testing (Simulation) function allows you to edit and output voltage patterns
that simulate power line anomalies such as blackout, voltage rise, voltage drop, abrupt phase change,
and abrupt frequency change. This section describes the basics for using the Simulation function.
 AC/DC Mode and Signal Source
Simulation function sets the AC/DC mode and a signal source, independently from Continuous
function/Sequence function. The setting is fixed to ACDC-INT.
 Keep simulation setting file
The simulation setting is cleared when the power is turned off. To save the setting, you need to save
it in internal memory or USB memory (see
4.9
).

Step
The output by the Simulation function consists of six types of steps: Initial, Normal 1, Trans 1,
Abnormal, Trans 2, and Normal 2. Before the simulation starts, the KP3000GS stands by at the
Initial Step. During the simulation, the step changes in the order of Initial, Normal 1, Trans 1,
Abnormal, Trans 2, and Normal 2. After the simulation ends, the KP3000GS returns to the Initial
Step and stands by.
 Step parameter
Each parameter of Step Time, AC voltage, frequency, start phase, stop phase, trigger output, and
synchronization output can be set for each step. However, some parameters cannot be set in some
steps.
Icon
Measured Value
to be displayed
Output setting
of initial step