NF KP3000GS, Instruction Manual

Page: 84 / 279

4.2 Using Sequence Function
KP3000GS 65
4.2.3 Example of Output Using Sequence Function
As an example, consider the sequence that gradually changes DC voltage like Figure 4–4.
Set the output mode to DC-INT. Edit the sequence like Table 4-3. Parameters not included in this
table should be left as the factory default setting.
100V
50V
0V
20s 10s 15s 5s
Keep
Sweep
Const
Hold
Sweep
Step0
Start Stop
Step1 Step2 Step3 Step0
O
u
tput v
olt
age
Time
Start operation Stop operation
Figure 4-4 Example of Sequence
Table 4-3 Example of Editing Sequence
Step Number 0 1 2 3
Step-control
parameter Step Time (Time) 5 s 20 s 10 s 15 s
Jump-to (Jump To) — OFF OFF OFF
Step termination (Step Term) — Continue Continue Hold
Intra-Step
Parameter DC Voltage (DCV) 0 V +100 V (Optional) +50 V
Step Behavior Sweep Sweep Keep Const
--------
Notes ------------------------------------------------------------------------------------------------------------
 Step Time and the Step Behavior of step No. 0 specifies the action after the transition to step
No. 0 at the end of a sequence.
 Jump-to of step No. 0 cannot be specified. The execution always transitions to step No. 1 when
the sequence starts.
 In the case that the step termination is set to [Hold] (No. 3), and when the execution is in the
Hold state, it transitions to step No. 0 and enters into the stand-by state if the Stop operation is
executed. If you perform Resume operation here, the execution transitions to the step of the
next number (No. 4).
-----------------------------------------------------------------------------------------------------------------------------
4.2.4 Process Flow in a Step
Figure 4–5 shows the process flow in one step. The transition such as Figure 4–6 occurs by branch
operation or stop operation, regardless of the flow in the step.